Woodward easYgen-2000 Series User Manual page 228

Configuration
Configure Application > Analog Outputs 3/4
ID Parameter
5236 User defined
min. output
5250
value
(User defined
minimum output
value)
5237 User defined
max. output
5251
value
(User defined
maximum
output value)
Setting ranges
228
CL Setting range Description
[Default]
[Off] No analog output signal will be issued.
user defined A maximum range of +/-20 mA / +/-10 V may be limited using the parame‐
ters
Notes
For a list of available signal ranges refer to
selection" Table on page 228
2 0.00 to 100.00 The minimum output value, which shall correspond with the minimum value of
% the output range, must be entered here.
[0.00 %]
Notes
This parameter is only active, if parameter
set to "user defined".
Example
If the value configured here is 25 %, the maximum output range of +/-20 mA /
+/-10 V has a lower limit of -10 mA / -5 V.
2 0 to 100.00 % The maximum output value, which shall correspond with the maximum value
of the output range, must be entered here.
[0.00 %]
Notes
This parameter is only active, if parameter
set to "user defined".
Example
f the value configured here is 75 %, the maximum output range of +/-20 mA /
+/-10 V has a upper limit of 10 mA / 5 V.
Type
Current
Voltage
easYgen-2200/2500 | Genset Control
5236 Ä p. 228 and 5237 Ä p. 228
Setting in parameter External
5229/5243 resistor
0 to 10mA (0 to 5V) no
0 to 20mA (0 to 10V)
4 to 20mA
10 to 0mA (5 to 0V)
20 to 0mA (10 to 0V)
20 to 4mA
User defined
0 to 10mA (0 to 5V) yes
0.5V to 4.5V
0 to 20mA (0 to 10V)
10 to 0mA (5 to 0V)
4.5V to 0.5V
to obtain a user defined range.
Ä "Analog outputs - signal type
5229 Ä p. 227/5243 Ä p. 227
5229 Ä p. 227/5243 Ä p. 227
Range Lower Upper
level level
0-10mA 0 mA 10 mA
0-20mA 0 mA 20 mA
4-20mA 4 mA 20 mA
10-0mA 10 mA 0 mA
20-0mA 20 mA 0 mA
20-4mA 20 mA 4 mA
0 to 5V 0 Vdc 5 Vdc
0.5 to 0.5 Vdc 4.5 Vdc
4,5V
0 to 10V 0 Vdc 10 Vdc
5 to 0V 5 Vdc 0 Vdc
4.5 to 4.5 Vdc 0.5 Vdc
0,5V
is
is
37535B