Woodward easYgen-2000 Series User Manual page 374

Application
Special Applications > Configuring A Setpoint Con...
Configuring the rated generator
power
ID Parameter
1752 Gen. rated active
power [kW]
Table 70: Parameters for rated generator power
Configuring the analog input for
real power setpoint
ID Parameter
1100 Type
1101 User defined min
display value
1102 User defined
max display
value
1139 Sender value at
display min.
1140 Sender value at
display max.
1120 Sender type
1103 Monitoring wire
break
1104 Wire break alarm
class
1105 Self acknowl‐
edge wire break
10116 Filter time con‐
stant
3636 Bargraph min‐
imum
3637 Bargraph max‐
imum
374
1. Either on the front panel or using ToolKit navigate to menu
"Configure measurement" .
2.
Configure the parameter listed in
generator power" Table on page 374 .
Value Comment
2000 Generator rated power of 2 MW
1. Either on the front panel or using ToolKit navigate to menu
"Configure analog inputs è Analog input 3" .
2. Configure the parameters listed below.
Value Comment
Linear A user-defined linear characteristic curve is to be used
+00000 A value of 000.00 % is displayed at the minimum of the input range
+10000 A value of 100.00 % is displayed at the maximum of the input range
020.00 % The sender value at minimum display is 20 % i.e. 4 mA
100.00 % The sender value at maximum display is 100 % i.e. 20 mA
0 - 20 mA A 0 to 20 mA sender is used on the analog input
Low If the analog signal falls below 2 mA, a wire break is indicated
Class B An alarm of class B will be issued in case of a wire break
No A wire break is not automatically cleared after it has been repaired
Off No filter time constant is applied to the analog signal
+00000 The start value for the bargraph display of the analog input is 00000
+10000 The end value for the bargraph display of the analog input is 10000
easYgen-2200/2500 | Genset Control
Ä "Parameters for rated
37535B