Woodward easYgen-2000 Series User Manual page 398

Application
Special Applications > Setup Phoenix Expansion Mo...
Setup baud rate
398
Fig. 185: Configuring Phoenix modules
It is possible to use multiple Phoenix modules with one bus cou‐
pler.
There is a maximum of three bus couplers on the CAN
bus. There is also a maximum of DI/DO 1..16, which
must not exceeded in all possible combinations.
Set the baud rate of CAN #2 in the easYgen and the Phoenix
module to the same value. All members on the CAN bus need to
have the same baud rate.
Fig. 186: Baud rate DIP switches
Each bus coupler has 10 DIP switches. These switches are located
on the left side of the CANopen bus coupler. DIP switches 1
through 7 are used to set the node address and DIP switches 8 to
10 are used to set the baud rate.
easYgen-2200/2500 | Genset Control 37535B