Woodward easYgen-2000 Series User Manual page 223

User defined max. output value
PWM signal
PWM output value
General notes
ID Parameter
5200 Data source
5214
5204 Source value
at minimal
5218
output
5206 Source value
at maximal
5220
output
37535B
ID Analog output 1
default values
5209 ---
5202 Off
5210 ---
CL Setting range Description
[Default]
2 Determined by The data source may be selected from the available data sources.
Analog Manager
Notes
AO1: [00.03
Refer to
Speed bias]
sources.
AO2: [00.02
Voltage bias]
2 -32000 to 32000 The value from the data source must exceed the value configured here to
raise the output signal above 0 %. Negative percentage values may be used
[0]
to change the sign, e.g. for power.
The entry format of the value depends on the selected data source.
Notes
If the monitored analog value has a reference value, the threshold is
expressed as a percentage of this reference value (-320.00 % to 320.00 %).
If an analog input is monitored, the threshold refers to the display value
format (
2 -32000 to 32000 If the value from the data source reaches the value configured here, the
output signal will reach 100 %. Negative percentage values may be used to
[10000]
change the sign, e.g. for power.
The entry format of the value depends on the selected data source.
Notes
If the monitored analog value has a reference value, the threshold is
expressed as a percentage of this reference value (-320.00 % to 320.00 %).
If an analog input is monitored, the threshold refers to the display value
format (
easYgen-2200/2500 | Genset Control
Configure Application > Analog Outputs 1/2
ID Analog output 2
default values
5223 ---
5216 Off
5224 ---
To get the standard PWM signal it is necessary to set
parameter 5201 Ä p. 224
"user defined". If this parameter is configured to "user
defined", the range is limited by parameters
5208 Ä p. 224 (User defined min. output value) and
5209 Ä p. 224 (User defined max. output value).
Parameters 5208 Ä p. 224
have a meaning unless parameter
set to "user defined".
Ä Chapter 9.3.1 "Data Sources" on page 533 for a list of all data
Ä Chapter 9.3.2.16 "Display Value Format" on page 548 ).
Ä Chapter 9.3.2.16 "Display Value Format" on page 548 ).
Configuration
Example 1 Example 2
100.00 % (20 100.00 %
mA)
Off On
--- 6 V
(Selected hardware type) to
and 5209 Ä p. 224 don't
5201 Ä p. 224 is
223