Woodward easYgen-2000 Series User Manual page 445

Modbus Applications > Changing Parameter Settings > Configuration Of LogicsMan...
Word 0 Word 1
Delay ON Delay OFF
0.00 sec 0.00 sec
0000 (hex) 0000 (hex)
low high low high
byt byte byt byte
e e
0000 (hex) 0000 (hex)
6.6.2.4.6 Configuration Of LogicsManager Function "Start w/o Load"
37535B
To configure the "External acknowledge" LogicsManager function
(parameter
Modbus message must be sent to the easYgen:
Word 2
Logic equation 1*
Sig Oper‐ Sign Oper‐
n 1 ator 1 2 ator 2
Or Or
¾ ¾
1 2 1 2
"as is"
1212 (hex)
Fig. 231: Modscan32 at address 12491
Copy the complete message of 7 words to address 12491 ff
(12490+1) in one step.
This is shown in (Fig. 231) using the ModScan32 software.
The Start w/o load LogicsManager function (parameter
12540 Ä p.
bled.
Refer to
Acknowledgement" on page 376 for information on configuration
via HMI or ToolKit.
easYgen-2200/2500 | Genset Control
12490 Ä p. 180) as indicated in (Fig. 230) the following
Word 3
Logic equation 2*
Sig -/- -/- -/-
n 3
Fal 00 00 00
se
3 0 0 0
"as is"
3000 (hex)
247) can be configured in a way that it is always ena‐
Ä Chapter 6.4.4 "Performing Remote Start/Stop And
Application
Word 4 Word 5 Word 6
Command Command Command
1 2 3
No. 09.05 No. 04.14 No. 00.01
ID = ID = ID =
523 dec 252 dec 0 dec
020B (hex) 00FC (hex) 0000 (hex)
low high low high low
byt byte byt byte byt
e e e
0B02 (hex) FC00 (hex) 0000 (hex)
high
byte
445