External Discrete Outputs - Woodward easYgen-2000 Series User Manual

ID Parameter
12580 Ready for op.
Off
(Ready for oper‐
ation OFF)
12110 Relay {x}
Parameter IDs
R 1
Parameter ID 12580
Table 49: Discrete outputs - relay parameter IDs
4.5.6

External Discrete Outputs

37535B
CL Setting range Description
[Default]
2 Determined by The "Ready for operation OFF" relay is energized by default if the power
LogicsManager supply exceeds 8 V.
Once the conditions of the LogicsManager have been fulfilled, the relay will
be de-energized. This LogicsManager output may be configured with addi‐
tional conditions, which may signal a PLC an "out of operation" condition by
de-energizing the relay on terminals 41/42, like "shutdown alarm" or no
"AUTO mode" present.
Notes
For information on the LogicsManager and its default settings see
Ä Chapter 9.4.1 "LogicsManager Overview" on page 549 .
2 Determined by Once the conditions of the LogicsManager have been fulfilled, the relay will
LogicsManager be energized.
Notes
For information on the LogicsManager and its default settings see
Ä Chapter 9.4.1 "LogicsManager Overview" on page 549 .
R 2 R 3 R 4
12110 12310 12320
If a Woodward IKD 1 or other external expansion board (Phoenix
Contact) is connected to the easYgen via the CAN bus, it is pos‐
sible to use 16 additional discrete outputs.
easYgen-2200/2500 | Genset Control
Configure Application > External Discrete Outputs
The parameter IDs above refers to relay 2.
Refer to Ä "Discrete outputs - relay parameter
–
IDs" Table on page 221 for the parameter IDs of
the parameters for relay 3 to relay 11.
R 5 R 6 R 7
12130 12140 12150
Configuration
R 8 R 9 R 10
12160 12170 12180
R 11
12560
221