Installation
Mount Unit (Plastic Housing) > Screw Kit Installation
Fig. 12: Tighten clamping screws
Fig. 13: Reattach terminals
3.1.2
Screw Kit Installation
34
6.
Tighten the clamping screws (Fig. 12/1) until the control unit
is secured to the control panel (Fig. 12/2). Over tightening of
these screws may result in the clamp inserts or the housing
breaking. Do not exceed the recommended tightening torque
of 0.1 Nm.
7.
Reattach the wire connection terminal strip (Fig. 13) and
secure them with the side screws.
The housing is equipped with 8 nut inserts (Fig. 14),
which must all be tightened properly to achieve the
required degree of protection.
easYgen-2200/2500 | Genset Control
37535B