Connecting A Gsm Modem - Woodward easYgen-2000 Series User Manual

Application
Special Applications > Connecting A GSM Modem
ID Parameter
5200 Data source
5201 Selected hard‐
ware type
5208 User defined
min. output value
5209 User defined
max. output
value
5202 PWM signal
5210 PWM output
level
Table 75: PWM duty cycle configuration
6.4.7

Connecting A GSM Modem

Fig. 172: Connecting a GSM modem
388
Configure the parameters as shown below.
Value Comment
[00.03] Speed A speed signal will be output
bias
User defined A user-defined hardware type will be used
10.00 % The minimum output value of the user-defined hardware type is 10 %
85.00 % The minimum output value of the user-defined hardware type is 85 %
On The PWM signal is enabled
10.00 V The PWM output level is configured to 10 V
ð The finished configuration in ToolKit is shown in
(Fig. 171).
Fig. 171: PWM duty cycle for a CAT ADEM controller (example
ToolKit)
easYgen-2200/2500 | Genset Control 37535B