Automatic Run - Woodward easYgen-2000 Series User Manual

Configuration
Configure Application > Automatic Run
4.5.11

Automatic Run

General notes
Engine start conditions
Fig. 93: Automatic run - engine start conditions
ID Parameter
12120 Start req. in
AUTO
(Start request in
operation mode
AUTOMATIC)
246
The start of the engine can be performed via the following different
logical conditions.
A discrete input
n
A temperature level
n
An interface start condition
n
A start request from the LDSS function
n
A timer
n
Any logical combination
n
If this logical output becomes TRUE in AUTOMATIC operating
mode, the generator starts and the GCB will be closed. The simul‐
taneous activation of other LogicsManager outputs (e.g. Stop req.
in Auto) may affect this function.
The breaker handling depends on the configured application mode
and breaker logic.
CL Setting range Description
[Default]
2 Determined by Once the conditions of the LogicsManager have been fulfilled, the control
LogicsManager issues a start request in AUTOMATIC mode.
[(09.02 ≥ 0) ≥ 0]
Notes
For information on the LogicsManager and its default settings see
Ä Chapter 9.4.1 "LogicsManager Overview" on page 549 .
easYgen-2200/2500 | Genset Control
Refer to Fig. 93 and Ä Chapter 9.4.3 "Logical Outputs"
on page 553 for the priority of the logical outputs in
case that more than one logical output is TRUE.
37535B