Woodward easYgen-2000 Series User Manual page 210

Configuration
Configure Application > Inputs And Outputs > Analog Inputs
4.5.2.1.2 Analog Inputs 1 to 3
General notes
ID Parameter
Analog input
{x}: Descrip‐
tion
1025 Input 1
1075 Input 2
1125 Input 3
Analog input
{x}: Type
1000 Input 1
1050 Input 2
1100 Input 3
User defined
min. display
value
(User defined
minimum dis‐
play value)
210
CL Setting range Description
[Default]
2 user-defined The event history will store this text message and it is also displayed on the
visualization screen.
1 to 16 charac‐
ters If the programmed limit value of the analog input has been reached or
exceeded this text is displayed in the control unit screen.
[Analog inp.
{x}]
Notes
This parameter may only be configured using ToolKit.
2 According to the following parameters different measuring ranges are pos‐
sible at the analog inputs.
[Off] The analog input is switched off.
VDO 5 bar The value of the analog input is interpreted with the VDO characteristics 0 to
5 bar.
VDO 10 bar The value of the analog input is interpreted with the VDO characteristics 0 to
10 bar.
VDO 150 °C The value of the analog input is interpreted with the VDO characteristics 50 to
150 °C.
VDO 120 °C The value of the analog input is interpreted with the VDO characteristics 40 to
120 °C.
Pt100 The value of the analog input is interpreted with a Pt100 characteristic.
Linear Each analog input may be assigned to a linear characteristic curve, which can
be only used for the respective defined input [T{x}] (x = 1 to 2). The minimum
(0 %) and maximum (100 %) value refers to the total measuring range of the
analog input (i.e. 0 to 500 Ohm or 0 to 20 mA) or the values configured as
"Sender value at display min." (parameter
1139 Ä p.
eter
Table A/B The analog input is assigned to a characteristic curve which is defined over
9 points (stored in a table). Two independent tables (table A and table B) may
be allocated to the analog inputs.
Note that if these tables are to be used with the analog inputs, the defined
points of these tables must be programmed into the control unit.
Notes
For the characteristic curves of the inputs refer to
Inputs Characteristics" on page 486 .
2 -32000 to 32000 The value to be displayed for the minimum of the input range must be entered
here.
[0]
easYgen-2200/2500 | Genset Control
Monitoring of the analog inputs (overrun/underrun)
must be configured manually to the flexible limits
(Ä Chapter 4.4.5 "Flexible Limits" on page 175).
211) and "Sender value at display max." (param‐
1040 Ä p. 211, 1090 Ä p. 211
1039 Ä p. 211, 1089 Ä p. 211
or 1140 Ä p. 211).
Ä Chapter 9.1.2 "VDO
or
37535B