Woodward easYgen-2000 Series User Manual page 342

Operation
Front Panel Access > Basic Navigation
Status and alarm messages
Single line diagram
Softkeys
Group Softkey
Display
Mode
Operation
342
The "status and alarm message" section (Fig. 118/2) of the screen
shows the actual operating information.
The single line diagram (Fig. 118/3) shows the current status of the
engine and power circuit breakers.
The softkeys (Fig. 118/4) permit navigation between screens,
levels and functions as well as configuration and operation.
Caption
Display Mode
AUTOMATIC Mode
MANUAL Mode
STOP
Increase Value
easYgen-2200/2500 | Genset Control
If the mains data display is disabled, the main screen
will only show generator data with bigger digits.
The section's content changes based on the selected
sub-menu screen.
For information on specialized menu screens refer to
Ä Chapter 5.2.4 "Specialised Menu Screens"
on page 347
For a list of all operation states refer to
Ä Chapter 9.5.3 "Status Messages" on page 589.
For a list of all alarm messages refer to
Ä Chapter 9.5.4.2 "Alarm Messages" on page 593.
This section is also used for manual operation of the
genset.
For additional information refer to Ä Chapter 5.3.2
"Operating Mode MANUAL" on page 354.
Description
Toggle between delta/wye voltage display.
Selects AUTOMATIC operating mode.
Selects MANUAL operating mode.
Selects STOP mode (Hardware button).
Pressing the STOP button for at least 10 seconds, restores the
default display settings for brightness and contrast.
Increase selected value.
37535B