Woodward easYgen-2000 Series User Manual page 584

Genset control

Hide thumbs Also See for easYgen-2000 Series:

Table of Contents

LogicsManager Reference > Factory Settings

Simple (function)

If TRUE, load-dependent start/stop segment no.

{y} is enabled.

Deactivated by default.

Only available in operating mode "AUTO" and

application mode

[00.9x] LDSS Priority {y}; {x} = 0 to 2; {y} = 2 to 4

If TRUE, load-dependent start/stop priority {y} is

Deactivated by default.

Only available in operating mode "AUTO" and

application mode

[00.9x] Transition mode {y}; {x} = 3 to 4; {y} = 1 to 2

If TRUE, transition mode {x} is enabled.

Deactivated by default.

Only available in operating mode "AUTO" and

application mode

Relay outputs

Simple (function)

[00.41] Relay 1 [R01] - Ready for operation OFF

Relay will be de-energized if unit is not ready for

operation or the LogicsManager output is TRUE.

Deactivated by default

Note: This function is pre-configured and may be

activated by passing through the command vari‐

ables [01.09] Shutdown alarm or [04.01] Oper‐

ating mode AUTO or [00.01] LM: Flag 1 ('―'

instead of '0').

The unit is only ready for operation after an start-

up delay following the power supply connection.

[00.42] Relay 2 [R02] - Centralized alarm (horn) / freely configurable

Relay energizes if the internal condition "Horn" is

Extended (configuration)

easYgen-2200/2500 | Genset Control

dependent on

mand Variable