Discrete Outputs (Logicsmanager) - Woodward easYgen-2000 Series User Manual

Configuration
Configure Application > Discrete Outputs (LogicsMa...
4.5.5

Discrete Outputs (LogicsManager)

Relay
No. Terminal
[R 01] 30/31
[R 02] 32/33
[R 03] 34/35
[R 04] 36/37
[R 05] 38/39/40
[R 06] 41/42
[R 07] 80/81
[R 08] 82/83
[R 09] 84/85
[R 10] 86/87
[R 11] 88/89
Table 48: Internal relay outputs - assignment
220
The discrete outputs are controlled via the LogicsManager.
Some outputs are assigned a function according to the application
mode (see following table).
Application mode
None GCB open
LogicsManager; pre-assigned with 'Ready for operation OFF
CAUTION! Only relay [R 01] has an inverse logic. The relay opens (all other relays close), if the logical
output of the LogicsManager becomes TRUE.
LogicsManager; pre-assigned with 'Centralized alarm (horn)'
LogicsManager; pre-assigned with 'Starter'
LogicsManager; pre-assigned with 'Diesel: Fuel solenoid, Gas: Gas valve'
LogicsManager; pre-assigned with 'Alarm class A, B active'
LogicsManager
LogicsManager Command: open GCB
LogicsManager
LogicsManager; pre-assigned with 'Stop solenoid'
LogicsManager; pre-assigned with 'Auxiliary services'
LogicsManager; pre-assigned with 'Alarm class C, D, E, F active'
easYgen-2200/2500 | Genset Control
For information on the LogicsManager and its default
settings see Ä Chapter 9.4.1 "LogicsManager Over‐
view" on page 549.
GCB open/close
Command: close GCB
CAUTION!
Uncontrolled operation due to faulty configuration
The discrete output "Ready for operation OFF" must
be wired in series with an emergency stop function.
This means that it must be ensured that the generator
circuit breaker is opened and the engine is stopped if
this discrete output is de-energized.
If the availability of the plant is important, this fault
must be signaled independently from the unit.
GCB/MCB open/close
Command: open MCB
Command: close MCB
37535B