Mains Rated Current; Rated Speed - Woodward easYgen-2000 Series User Manual
Genset control
Hide thumbs
Also See for easYgen-2000 Series:
- Configuration manual (339 pages) ,
- Installation manual (72 pages) ,
- Manual (52 pages)
Table of Contents
Advertisement
9.3.2.12
Mains Rated Current
Analog output example
Flexible limit example
9.3.2.13
Rated Speed
Analog output example
Flexible limit example
37535B
Analog Manager Reference > Reference Values > Rated Speed
All mains current values (line, average, and peak values) refer to
the mains rated current (parameter
The mains rated current (parameter
n
ured to 1000 A.
The source value at maximum output is configured to 110.00
n
% (of the rated current i.e. 1100 A).
The source value at minimum output is configured to 10.00
n
% (of the rated current i.e. 100 A).
The analog output range is configured to 0 to 20 mA.
n
If a mains current of 100 A (or below) is measured, the
n
analog output issues its lower limit (i.e. 0 mA).
If a mains current of 1100 A (or above) is measured, the
n
analog output issues its upper limit (i.e. 20 mA).
If a mains current of 600 A is measured, the analog output
n
issues 50 % of its upper limit (i.e. 10 mA).
If a mains current of 300 A is measured, the analog output
n
issues 20 % of its upper limit (i.e. 4 mA).
The mains rated current (parameter
n
ured to 1000 A.
If the flexible limit is to be configured to 110.00 % (of the
n
rated current i.e. 1100 A), it must be entered as 11000.
The measured speed refers to the rated speed (param‐
eter
1601 Ä p.
95).
The rated speed (parameter
n
1500 rpm.
The source value at maximum output is configured to 120.00
n
% (of the rated speed i.e. 1800 rpm).
The source value at minimum output is configured to 0.00 %
n
(of the rated speed i.e. 0 rpm).
The analog output range is configured to 0 to 20 mA.
n
If a speed of 0 rpm is measured, the analog output issues its
n
lower limit (i.e. 0 mA).
If a speed of 1800 rpm (or above) is measured, the analog
n
output issues its upper limit (i.e. 20 mA).
If a speed of 900 rpm is measured, the analog output issues
n
50 % of its upper limit (i.e. 10 mA).
If a speed of 1500 rpm is measured, the analog output
n
issues ~83 % of its upper limit (i.e. 16.7 mA).
The rated speed (parameter
n
1500 rpm.
If the flexible limit is to be configured to 120.00 % (of the
n
rated speed i.e. 1800 rpm), it must be entered as 12000.
easYgen-2200/2500 | Genset Control
1785 Ä p.
95).
1785 Ä p.
95) is config‐
1785 Ä p.
95) is config‐
1601 Ä p.
95) is configured to
1601 Ä p.
95) is configured to
Appendix
547
Advertisement
Table of Contents
