Basic Navigation - Woodward easYgen-2000 Series User Manual

Display
STOP button
Hardware buttons
LEDs
5.2.2

Basic Navigation

Main screen
Fig. 118: Main screen
Values
37535B
The display shows context-sensitive softkey symbols, measuring
values, modes of operation, and alarms.
For information on the softkeys and menus refer to
Ä Chapter 5.2.2 "Basic Navigation" on page 341 and the following
chapters on specialized menu screens.
The "STOP" button is always active (independent of
context) and will stop the engine when pressed, except
when operating modes are selected externally.
In this case, the AUTO and MAN Mode push buttons
are also disabled.
The button groups provide the following functions via context-sen‐
sitive softkeys:
"Display" - Change the method of voltage and power calcula‐
tions displayed.
"Mode" - Change the mode of operation.
"Operation" - Used to perform manual operation of the genset
and the breakers.
"Navigation" - Navigation between system and configuration
screens, and alarm list.
The LEDs indicate the following states:
"STOP Mode" - The left LED indicates that the unit is in STOP
mode.
"ALARMS" - The right LED indicates that alarm messages are
active / present in the control unit.
After power-up the control unit displays the main screen (Fig. 118).
The main screen can be divided into the following basic sections:
1 Values
2 Status and alarm messages
3 Single line diagram
4 Softkeys
The "values" section (Fig. 118/1) of the screen illustrates all meas‐
ured power related information including voltages, currents, fre‐
quencies, power, and power factor values.
easYgen-2200/2500 | Genset Control
Front Panel Access > Basic Navigation
Operation
341