Woodward easYgen-2000 Series User Manual page 209

Genset control

Hide thumbs Also See for easYgen-2000 Series:

Table of Contents

X-coordinate (cor‐

Y-coordinate

X-coordinate (wrong)

Y-coordinate

Table {A/B} X-

value {1..9}

Table {A/B} Y-

value {1..9}

Parameter IDs for all scaling points

Scaling point no.

Table A - X value

Table A - Y value

Table B - X value

Table B - Y value

In the following example the first set of x/y coordinates are correct

and the second set of x/y coordinates are wrong:

Setting range

The analog input is assigned to a curve. This parameter defines the actual

percentage assigned to each of the nine points along the X-axis of the total

range of the selected hardware for analog input.

If a 0 to 20 mA input is configured and the X1-coordinate = 0 %, then the

value configured for Y1 is output for an input of 0 mA.

-9999 to 9999

This parameter defines the Y-coordinate (the displayed and monitored value)

at the corresponding X-coordinate.

If a 0 to 20 mA input is configured and the X2-coordinate = 10 %, then the

value configured for the Y2-coordinate is output for an input of 2 mA.

easYgen-2200/2500 | Genset Control

Configure Application > Inputs And Outputs > Analog Inputs

If the first X coordinate is >0 %, all values smaller than

the first X value will be output with the first Y value.

If the last Y value is <100 %, all higher values will be

output with the value of Y9.

All parameters used to configure the characteristic

curve follow the samples listed below.

Refer to for the parameter IDs of the individual

parameters for all scaling points of tables 'A' and

Configuration