Woodward easYgen-2000 Series User Manual page 375

ID Parameter
1125 Description
1135 Value format
Configuring the load controller
ID Parameter
5539 Load setpoint 1
source
5526 Load setpoint 1
5520 Int. load control
setpoint 1
5540 Load setpoint 2
source
5527 Load setpoint 2
Fig. 146: LogicsManager function
Viewing the load setpoint on the
easYgen
Fig. 147: Screen "Setpoint"
Fig. 148: Screen "Analog inputs"
37535B
3. Configure the following parameters using ToolKit. They facili‐
tate a more detailed display of the analog value.
Value Comment
ActivePower SP Analog input [AI 03] is labeled with "ActivePower SP (%)" on the display
(%)
000.00 % The value format of the bargraph display of the analog input is "000.00 %"
The load controller is to be configured that it uses a fixed load set‐
point 1 of 2 MW unless a switch energizes discrete input [DI 09] for
enabling a variable load setpoint 2, which is controlled by analog
input [AI 03].
1. Either on the front panel or using ToolKit navigate to menu
"Configure load control" .
2. Configure the parameters listed below.
Value Comment
05.04 Internal Internal power setpoint 1 is used as setpoint 1
pwr. setp.1
Constant A constant load is to be controlled for setpoint 1
02000.0 kW A constant load of 2 MW is to be used for internal setpoint 1
06.03 Analog Analog input 3 is used as setpoint 2
input 3
Constant A constant load is to be controlled for setpoint 2
3. Configure the LogicsManager function "Setp. 2 load" as
shown in (Fig. 146) to enable load setpoint 2 if discrete input
[DI 09] is energized.
"Setp. 2 load"
1. After the unit is configured as described above, the "Setpoint"
screen may be viewed from the main screen by selecting
"Main Menu è Setpoints" .
2. The "Analog inputs" screen may be viewed from the main
screen by selecting
è
easYgen-2200/2500 | Genset Control
Special Applications > Configuring A Setpoint Con...
"Main Menu è Measured values
Analog inputs/outputs" .
Application
375