Ip Multicast Admin-State - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Multicast Switching Commands

ip multicast admin-state

Enables or disables IP Multicast Switching and Routing on the specified VLAN, or on the system if no
VLAN is specified.
ip multicast [vlan vid] admin-state [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If an IP Multicast Routing protocol is already running on the system, the ip multicast admin-state
command will override the existing configuration and always enable IP Multicast Switching and Rout-
ing.
•
If the IP Multicast Switching and Routing is already enabled on the system, then the VLAN configura-
tion will override the system's configuration.
•
You can also restore the IP Multicast Switching and Routing to its default (i.e., disabled) status on the
system if no VLAN is specified, by using only ip multicast admin-state.
•
You can also restore the IP Multicast Switching and Routing to its default (i.e., disabled) status on the
specified VLAN, by using only ip multicast vlan vid admin-state.
Examples
-> ip multicast admin-state enable
-> ip multicast admin-state disable
-> ip multicast vlan 2 admin-state enable
-> ip multicast vlan 2 admin-state disable
-> ip multicast vlan 2 admin-state
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
VLAN on which to apply the configuration.
Enable IP Multicast Switching and Routing.
Disable IP Multicast Switching and Routing.
default
disable
March 2011
ip multicast admin-state
page 21-3