Ip Multicast Querier-Forwarding - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Multicast Switching Commands

ip multicast querier-forwarding

Enables or disables IGMP querier forwarding on the specified VLAN or on the system if no VLAN is
specified.
ip multicast [vlan vid] querier-forwarding [{enable | disable}]
no ip multicast [vlan vid] querier-forwarding
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an IGMP querier forwarding entry on the specified VLAN
or on the system and return to its default behavior.
•
If the IGMP querier forwarding is already enabled on the system, then the VLAN configuration will
override the system's configuration.
•
IGMP querier forwarding refers to promoting detected IGMP queriers to receive all IP multicast data
traffic.
Examples
-> ip multicast querier-forwarding enable
-> ip multicast querier-forwarding disable
-> ip multicast querier-forwarding
-> ip multicast vlan 2 querier-forwarding enable
-> ip multicast vlan 2 querier-forwarding disable
-> ip multicast vlan 2 querier-forwarding
-> no ip multicast vlan 2 querier-forwarding
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The VLAN on which configuration is applied.
Enable IGMP querier forwarding.
Disable IGMP querier forwarding.
default
disable
March 2011
ip multicast querier-forwarding
page 21-5