Boot System - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
boot system
Syntax
Release Information
Description
Options
Mode
306
boot system relFileName
Command introduced before JunosE Release 7.1.0.
Specifies the software release (.rel) file to use on reboot. There is no no version.
NOTE: In a dual SRP module configuration, when this information is synchronized to
the standby SRP module, the standby SRP module is reloaded to boot the specified
release. The high availability feature requires the release to be the same on the active
and the standby SRP modules. This means that arming the system to boot with a
different release causes the standby module to reload and prevent high availability
from becoming active or to disable high availability if it is active or pending.
relFileName—Name of the software release file (.rel) that contains the software release
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
