Bridge Route - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

bridge route

Syntax
Release Information
Description
Options
Mode
318
[ no ] bridge bridgeGroupName route { ip | mpls | pppoe }
Command introduced before JunosE Release 7.1.0.
Enables routing of IP, MPLS, or PPPoE packets in a specified bridge group when concurrent
routing and bridging (CRB) is enabled for all bridge groups on the router. The command
uses the routing table entries to determine the path on which to send the packet toward
its final destination. The no version disables routing of the specified protocol in the
specified bridge group.
If you issue this command for a protocol that is not currently configured in the interface
stack for that bridge group, the bridge group discards (drops) those packets.
NOTE: The bridge route command is available for a bridge group only after you issue
the bridge crb command to enable CRB for all bridge groups on the router.
The bridge route command is not valid for bridge groups configured as VPLS instances.
If you attempt to issue the bridge route command for a VPLS instance, the router
displays an error message and rejects the command.
bridgeGroupName—Name of a bridge group specified with the bridge command
ip—Specifies that the bridge group routes IP packets
mpls—Specifies that the bridge group routes MPLS packets
pppoe—Specifies that the bridge group routes PPPoE packets
Global Configuration
Copyright © 2010, Juniper Networks, Inc.