Bgp Graceful-Restart Stalepaths-Time - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
bgp graceful-restart stalepaths-time
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
bgp graceful-restart stalepaths-time seconds
no bgp graceful-restart stalepaths-time [ seconds ]
Command introduced before JunosE Release 7.1.0.
Sets the time period after a peer session restart for all peers during which BGP waits for
an End-of-RIB marker from a peer before flushing all stale routes from that peer. The
period is measured from when the session is detected in a down state. The no version
restores the default value, 360 seconds.
seconds—Integer in the range 1–3600; default value is 360 seconds
Router Configuration
Chapter 3: B Commands
291
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers