Boolean-Test - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

boolean-test

Syntax
Release Information
Description
Options
Mode
298
boolean-test { comparison comparisonType | event eventOwner eventName
| startup |
value booleanValue }
no boolean-test [ comparison | event | startup | value ]
Command introduced before JunosE Release 7.1.0.
Defines Boolean test values for the trigger that you are configuring, including comparison
settings, a Boolean value, a startup condition, and binding an event to the boolean-test
trigger. The no version deletes the Boolean-test values for this trigger or removes either
the startup condition or event binding.
comparisonType—One of the following types of Boolean comparison to perform: (equal,
greater, greaterOrEqual, less, lessOrEqual, unequal
eventOwner—Name of event owner that partially specifies event to trigger the Boolean
test; string of up to 32 alphanumeric characters
eventName—Name of event that partially specifies event to trigger the Boolean test;
string of up to 32 alphanumeric characters
startup—Specifies not to perform the Boolean comparison when this trigger first
becomes active
booleanValue—Value in the range -2147483648–2147483647 to use for the Boolean
test
SNMP Trigger Configuration
Copyright © 2010, Juniper Networks, Inc.