Bridge Vpls Route-Target - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

bridge vpls route-target

Syntax
Release Information
Description
Options
Mode
322
[ no ] bridge vplsName vpls route-target { import | export | both } extendedCommunity
Command introduced in JunosE Release 7.1.0.
Creates or adds to a list of VPN extended communities that the router uses to determine
which routes are imported by a VPLS instance that uses BGP as the signaling protocol.
The no version removes a route target from the specified list.
A route is imported into the BGP address family for a specified VPLS instance when both
of the following conditions are met:
An update message with a route-target export list advertises a route.
That list contains at least one route target that matches a route target in the
route-target import list associated with a VPLS instance.
The bridge vpls route-target command is not valid for a VPLS instance that uses LDP
as the signaling protocol. To configure a VPLS instance with LDP signaling, use the mpls
ldp vpls vpls-id command and the mpls ldp vpls neighbor command.
NOTE: The bridge vpls route-target command is available for a VPLS instance only
after you issue the bridge vpls transport-virtual-router command, which creates the
VPLS instance and configures the transport virtual router.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
import—Adds the route target to the specified VPLS instance's import list; the VPLS
instance accepts only routes that have at least one route target that matches a route
target in the import list
export—Adds the route target to the specified VPLS instance's export list; all routes
advertised from this VPLS instance are associated with the export list
both—Adds the route target to both the import list and export list of the specified VPLS
instance. This is the recommended setting for a VPLS instance
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, where:
number1—Autonomous system (AS) number or an IP address
number2—Unique integer; 32 bits if number1 is an AS number; 16 bits if number1 is an
IP address
Global Configuration
Copyright © 2010, Juniper Networks, Inc.