Mitel SX-200 Practices page 94

Features Description
9 Valid forward destinations are: hunt groups (not data or modem pool),
consoles, telephones, Abbreviated Dial numbers, Dial 0 access code,
LDN, Night Bells, and ACD paths.
l
The cancel of all Forwarding by the Console only applies to extensions
for which Device Interconnection Control checks pass between the
Console and the extension.
Programming
In Generic 1004 and Generic 1005, enable COS Option 123 - Attendant
Call Forward Setup and Cancel in the Attendant COS, and if split call for-
warding is required, enable COS Option 260 (Internal/External Split Call
Forwarding).
Operation
To set up Call Forwarding to an internal number, perform the following
procedure:
l
Press the FUNCTION key.
l
Press the ATT FUNCTION softkey.
l
Press the STATIONS softkey.
l
Dial the extension number.
l
Press the CALL FWD softkey.
l
Press the EXTERNAL or INTERNAL softkey (only when split forward-
ing enabled).
. Enter the desired call forward destination extension number.
l
Press the ALWAYS or NO ANSWER or ON BUSY or BUSY/NO ANS
softkey.
To set up Call Forwarding to an external number, press the following keys in
this sequence:
l
Press the FUNCTION key,
l
Press the ATT FUNCTION softkey.
. Press the STATIONS softkey.
9 Dial the extension number.
9 Press the CALL FWD softkey.
9 Press the EXTERNAL or INTERNAL softkey (only when split forward-
ing enabled).
l
Enter the desired call forward destination speed call number.
l
Press the ALWAYS or NO ANSWER or ON BUSY or BUSY/NO ANS
softkey.
To review Call Forwarding for an extension, press the following keys, in this
sequence:
l
Press the FUNCTION key.
105 2-22
Revision
0 9109-096-105-NA Issue
1