Mitel SX-200 Practices page 634

Hide thumbs Also See for SX-200:
Table of Contents

Advertisement

Traffic Measurement
a traffic
measurement
period.
At the
beginning
of each
period
of current
traffic
measurement,
the pegs and dynamic
records
are initialized.
If a new trunk group was
set up by CDE, it would not be included
in the traffic report until the next period.
STOP Command
-This
command
causestwo
softkeys to become
active. By pressing
either softkey, you select what is to be stopped,
TRAFFRPT
- Stops the traffic measurement
which is currently
active. No report
will be made of the incomplete
collected
data.
PRINT - Stops a printout from being sent to the PRINTER
port.
'Note:
The STOP command will not stop an AUTOPRINT
in progress.
The AUTOPRINT
command must be set to OFF between
printouts
to stop printouts.
SHOW
STATUS
Command
- Contains
a summary
report
on the current
traffic
measurement
parameters.
STATUS:
START TIME:
DATA COLLECTION:
PERIOD:
DURATION:
AUTOPRINT
UNITS:
CONDENSED
REPORT
Activated/OFF
hh:mm
(hours:minutes)
Running/OFF
mm (minutes)
nn (periods)
ON/OFF
Erlangs/CCS
ON/OFF
START TIME and DATA COLLECTION
are not displayed
if STATUS is set to OFF.
SET STATUS OFF
press STOP
press TRAFFRPT
press ENTER
STATUS
is set to OFF
DATA COLLECTION:
This indicates
that data is currently
being collected
if traffic is
being measured.
When it is set to OFF, either the daily start time has not been reached,
'or, it has finished
the required
number
of periods since the start time.
In either case,
no data is currently
being collected.
PRINT
This softkey command
causes the latest traff ic report held in the system
to be printed
immediately.
READ:
This softkey command
causes the latest traffic report in the system
to
be displayed
on the maintenance
terminal
where
it may be read by the user.
READ is only available
at the Maintenance
Terminal.
If the Console
softkey
is
pressed,
the following
message
appears
on the LCD display:
This function is not available for this device
QUIZ
This softkey command
allows the user to exit from Traffic Measurement
mode at the console
or maintenance
terminal.
60
3-2
Revision
0
9109-0944504A
Issue 1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents