Mitel SX-200 Practices page 633

3
' TRAFFIC MEASUREMENT
COMMANDS
Maintenance Terminal and Console
3.1
The maintenance terminal or console is used to enter the data required to start traffic
measurements, print measurements, monitor status, or change traffic measurement
\
parameters. Refer to Practice 9109-096-351-NA, RS-232 Maintenance Terminal,
for instructions on using the terminal. At the maintenance terminal or console, select
the MAINTENANCE application. From the MAINTENANCE main menu, select
TRAFFIC MEAS (softkey 5).
Tratfic Commands
1 l-SET
b-SHOW 13-PRINT IdaAD is-
I
7-
a- 9- STOP o-
I
SET Set traffic report information
SHOW
Status of current traffic report that contains information
defined by the SET command
PRINT Print the latest traffic report
READ Read the latest traffic report
STOP Stop current traffic measurements or stop printing report
SET Command
l-UNITS 2- PERIOD 3- DURATION 4- AUTOPRINT 5- CANCEL
I
b-
174TART TIME 1 S-CONDENSED 1%
IO-
I
UNITS
PERIOD
DURATION
CONDENSED
CANCEL
START TIME
AUTOPRINT
CCS or Erlangs
I to 60 minutes (default = 60)
Number of periods default = 8)
Condensed report (toggles ON or OFF)
Quit SET commands
Presented in hours:minutes format (hh:mm)
Print report automatically after each period (toggles ON or OFF)
Select the SET command to enter or change any traffic measurement parameters.
Use
the prompts to change required data and to exit from the TRAFFIC MEAS function,
Setting START-TIME to a specific time prepares the traffic data collection facility.
Data
collection is only started when that time is reached. Until then, the PERIOD,
DURATION, and START-TIME parameters can be changed.
Once traffic
measurements are started, a STOP command must be issued first, followed by other
commands. The AUTOPRINT and CONDENSED parameters can be changed during
9109-09445O-NA Issue1
Revision
0
450 3-l