Mitel SX-200 Practices page 77

Features
COS Option 806 (SMDR - Record Incoming Calls) must be enabled in an
incoming trunk COS to permit account codes to be used on incoming calls on
the trunk to a SUPERSETtelephone.
Enable all of required SMDR options as outlined in Practice
9109-096-221 -NA, Station Message Detail Recording.
Enable System Option 36 (End Of Dial Character) for use with variable
length account codes.
To provide feature key activation for account codes at SUPB?SET3"DN, or
SUPERSET470" program an ACCOUNT CODE feature key. (See Feature
Keys.)
Operation
Operation varies depending upon the type of device as described below.
Industry Standard, SUPERSET3", and
SUPERSETQOI"
Telephones:
To access a trunk via account code entry:
9 Dial the access code for account code entry.
0 Dial the account code digits (if System Option 55 - Account Code
Length is selected, account code digits must be followed by a W to
indicate end of account code).
. Dial tone is returned. The account code entered now applies to the
trunk call immediately made while still listening to dial tone.
9 Dial the trunk call.
At the completion of the call, an SMDR record is printed. This printout
includes the time of call, trunk used, duration of call, and the Account Code.
SUPERSET
Telephones:
During a call, or immediately prior to dialing (listening to dial tone):
l
Press the SELECT FEATURES key.
0 Dial 5 (feature number 5 is Account Code (5:ACC CODE)).
l
Dial account code digits (DTMF tones are not heard) and if dialing, dial
tone is removed.
l
Press the SAVE key. The prompt PLEASE TRY LATER occurs if the
recording process is busy. The display reverts to the condition applica-
ble at that time;if dial tone had been removed, it is resumed.
There are two ways to correct an entry:
1. Press the 4 key to back space and erase one or more incorrect dig-
its.
2. Press the EXIT key to cancel the entire entry.
9109-096-l 05-NA
Issue 1 Revision 0
105 2-5