Mitel SX-200 Practices page 153

Features
.
.
To
.
.
.
Press the CALL FWD softkey - read the display.
Press the EXIT softkey.
activate Forwarding already programmed (split forwarding disabled):
Press the SELECT FEATURES key.
Dial 1 (feature number 1 is Forwarding (1 :FWD)) -the current type
and destination are displayed.
Press the ON softkey to activate forwarding;
press the EXIT softkey.
if activation is not desired,
Note:
A Feature Key may be used here instead.
Forwarding is now active; the word FWD is displayed in the top left corner of
the LCD as a reminder.
To deactivate Forwarding (split forwarding disabled):
.
.
.
Press the SELECT FEATURES key.
Dial 1 (feature number 1 is Forwarding (1 :FWD)) -the current type
and destination are displayed.
Press the OFF softkey to deactivate forwarding; if deactivation is not
desired, press the EXIT softkey.
Note:
A Feature Key may be used here instead.
To Set Up or Modify Call Forwarding - Busy (split forwarding disabled):
l
With the handset on-hook, press the PROGRAM feature key.
l
Press the CALL FWD feature key.
The alphanumeric display shows a Forwarding type. If the displayed type is
not the one required, press the NO softkey; another type is displayed.
Repeat until Call Forwarding - Busy; then press the YES softkey.
To forward the call within the PABX:
0 Dial the forwarding destination.
. Check the number on the display
- To correct an error, use the 4 key.
l
Press the SAVE softkey.
SUPERSET 420
Telephones:
To display the current forwarding type and destination (split forwarding
disabled):
l
Press
SuperKey.
9109-096-l 05-NA
issue 1 Revision 0
105 2-81