Callannounceport - Mitel SX-200 Practices

Features Descridion
Call Announce Port
Description
The Call Announce Port is an auxiliary port that allows a caller to commu-
nicate through the Handsfree speaker of a SUPERSET telephone. This
is possible while there is a call in progress at the telephone on the tele-
phone' s handset. The Call Announce Port itself occupies a separate line
circuit and is connected to the second pair on the SUPERSET tele-
,,phone. See
Call
Announce,
Override Announce, and Intercom for details
on the uses of a Call Announce Port.
;
Conditions The following conditions apply to this feature:
A Call Announce Port is available only on a SUPERSET telephone.
The SUPERSET 4 telephone can be busy or idle, but cannot be oper-
ating in Handsfree mode, when the Call Announce Port is accessed.
The Call Announce Port must be programmed for and connected to
the black/yellow (auxiliary) pair of its associated SUPERSET tele-
phone.
The Call Announce Port (CAP) must be connected to a COV card, a
digital OPS card or an analog Line Circuit card; hardware restrictions
prevent an ONS port being used for a CAP.
The Call Announce Port can accept only one caller at a time.
A Call Announce Port cannot be put on hold or consultation hold or
conferenced with a party on consultation hold.
The SUPERSET telephone must not be Handsfree (using the speak-
er) at the time that the call to the Call Announce Port is made. The
CAP is considered busy if this is the case.
No device connection checking is done between a Call Announce Port
and calling devices.
- Programming Program the Call Announce Port for the SUPERSET telephone in CDE
Form 09 (StationlSUPERSETTelephones).
Operation See
the features which access a Call Announce Port.
105 2-74
Revision 0
9109-096-I 05-NA
Issue 1