Mitel SX-200 Practices page 731

Programming Hotel/Motel
Chart 4-2 Programming for PMS
dotes: 1. The SX-200 DIGITAL PABX can be interfaced to a Property Management System. A
PMS is not available in Generic 1005 FPKG 1 and LlT96.
2, The PMS interface port is dedicated to PMS only. It cannot be used for any other appli-
cations such as CDE, SMDR or ACD.
3. Because PMS has exclusive use of the port assigned to it, a dataset should be used as
the port, allowing the system printer port to be used for other printouts.
4. Maintenance logs record any errors in the PMS interface. Refer to Practice
9109-096-35O-NA, Troubleshooting, for details.
5. PMS Terminal. Dial 0 calls are routed to a console (Form 19) or a console LDN or sub-
attendant LDN (Form 08). This makes sure there is a single place the guest must call to
receive messages. If the dial 0 point for the room is not a console or a console LDN or
subattendant LDN, the message softkey is not provided on the PMS terminal.
6. Message Waiting Setup must be enabled in the COS for the guest room phone if it is
an industry-standard telephone. This restriction does not apply to
SUPERSET 4,
SUPERSET 420, SUPERSET
4DN and
SUPERSET
430 telephones.
Step
Action Comments
Setting COS Options
1. On Form 03, Programming Feature Access
Codes:
Assign an access code to COS option 32
(Automatic Wakeup).
To allow room telephones to set automatic
wakeup. See also COS option 202 (Alarm
Call) m
Enable COS 35 (Maid in Room). To allow room status to be changed from
room telephones.
Enable COS option 105 (Attendant Guest
Room Key).
To allow the attendant to set automatic
wakeups. (see also System Option 11, Form
044
Also allows the attendant to set up or cancel
Do Not Disturb.
Enable COS option 202 (Alarm Call).
Also allows the attendant to set up or cancel
message waiting for a room telephone- See
also COS option 231 (Bell) or 232 (Lamp).
This COS option allows guests to set up a
wakeup alarm call from their extension. See
also COS option 244.
Enable COS option 220 (Do Not Disturb). This COS allows guests to set up and cancel
Do Not Disturb from their extension. See
also System Option 10 (Do Not Disturb),
Form 04.
Page lof 3
9109-096-602-NA
Issue 1 Revision 0
602
4-11