Mitel SX-200 Practices page 260

Features Description
Data: DTRX Messages
Description
The Data Transceiver (DTRX) Messages feature provides several mes-
sages to inform the user of call progress and error conditions.
This feature is not available in Generic 1001.
Table 24 DTFIX Messages
Message
DO101 Information -Ringing
DO102 Information -Connected
Meaning
The destination is available and is now ringing.
The user is now connected to the destination. This is the last message
displayed in a successful call. The DTRX is now dropped.
DO201 Call Failure - Busy The destination is busy and queuing is not enabled. The user is then
returned to the DTRX * prompt.
DO203 Call Failure - Invalid Number, The directory number does not exist. The user is returned to the DTRX
Check Directory
* prompt.
DO204 Call Failure - Out of Order, The destination data device has been busied out. This can indicate a
Call Communications Department
fault in the destination data device.
DO205 Call Failure - No Answer The destination auto answer dataset did not respond. The user is
returned to the DTRX * prompt.
DO207 Call Failure - Destination Not The DTR signal of the destination device (non auto answer) indicates It
Ready
is not ready. The user is returned to the DTRX * prompt.
DO208 Call Failure - Destination
The destination dataset has no power or is not connected to the PABX.
Powered Cff, Try Again Later
DO209 Call Failure - Destination Not The destination is a voice device and thus incompatible.
Compatible
DO21 0 Call Failure -Address
Further addressing information is required to complete the call. The
Incomplete, Check Directory
user is returned to the DTRX * prompt.
Do211 Call Failure - Modem Failure, The setup to the Pooled Modem has failed. The user is returned to the
Try Again
DTRX * prompt.
DO21 2 Call Failure - No Modem There are no idle members in the Modem Pool Hunt Group and
Available, Try Again Later
queuing is not enabled. The user is returned to the DTRX * prompt,
DO218 Call Failure - Destination Not The destination device' s data rate is not compatible with that of the
Compatible
source device. (Speed conversion is allowed if XON/XOFF Flow
Control is enabled). The user is returned to the DTRX * prompt.
DO301 Call Not Allowed - No
Access, Call Communications
Department
Access to the destination device is not allowed. This can be due to
tenanting,because the data station is programmed as Receive Only, or
because the destination is not accessible by the caller. The user is
returned to the DTRX * prompt.
Page lof 2
105 2-188
Revision 0
9109-096-l 05-NA
Issue 1