Attendant Flash Over Trunk - Mitel SX-200 Practices

Features
To remove the Busy-Out condition from an extension, perform the following
procedure:
l
Press the FUNCTION key.
l
Press the ATT FUNCTION softkey.
l
Press the STATIONS softkey.
l
Enter the extension number.
l
Press the BUSY OUT softkey.
l
Press the CLEAR softkey.
Attendant Flash Over Trunk
Description
The Attendant can flash on a trunk (any type) by pressing the FLASH
softkey. A flash is sent out on the trunk, and dialing is restarted on the
trunk.
Conditions The following conditions apply to this feature:
l
There must be only one party at the console.
l
The attendant may flash on incoming and outgoing trunks.
l
The trunk must be in a trunk group.
. The feature is not available when the console is locked out.
0 The flash duration is based on the trunk hardware used. For trunks in
Digital bays, the duration is programmed using the Flash Duration
Trunk Circuit Descriptor Option. For all other trunks, the time is approx-
imately 200 ms.
l
The flash type is programmable for certain trunks. See
Trunk Circuit
Descriptor Options (Generic 1004 and 1005). The Flash Over Trunk
Option is ignored when an attendant does a flash on a trunk.
l
If the trunk is the source party then the trunk becomes the destination
party.
l
Dialing continues until an inter-digit timeout or the maximum number
of digits (26) have been dialed. Digits dialed on the console keypad
are sent out on the trunk (tone or pulse) by the system, based on the
DTMF Trunk Circuit Descriptor Option for the trunk.
l
When dialing is restarted:
- If COS Option 802 (Limited
Wait For Dial Tone) is not enabled for
the trunk then the system will wait indefinitely for dial tone to be de-
tected. COS Option 805 (Trunk No Dial Tone Alarm) does not apply.
9109-096-105-NA
Issue1
Revision 0