Mitel SX-200 Practices page 734

Hotel/Motel Feature Package Description
Attendant Message Waiting
Feature Description:
Refer to page 602 2-24.
User Information:
Console: Chart 5-l ; Front Desk Terminal: Chart 5-l 7; Telephones:
Chart 5-S6.
Chart 4-3 Programming Attendant Message Waiting Setup and Cancel
4otes: 1. Front Desk Terminal. Dial 0 calls are routed to a console (Form 19) or a console LDN
or subattendant LDN (Form 08). This makes sure there is a single place the guest must
call to receive messages. If the dial 0 point for the room is not a console or a console or
subattendant LDN, the message softkey is not provided on the front desk terminal.
2. Message Waiting Setup must be enabled in the COS for the guest room phone if it's an
industry-standard telephone. This restriction does not apply to SUPERSET 4,
SLJPERSET 420, SUPERSET 4DN and SUPERSET 430 telephones.
step
Action Comments
Form 03
1. Enable COS option 105 (Attendant Guest
Room Key) for the console to access
message wafting from the Guest Room
softkey.
2. Enable COS option 231 (Message Waiting
Bell) for the guest room extension,
Room Telephones. This COS option rings
the bell on a room telephone when there is a
message waiting. See also System Option
or 02 (Form 04). COS options 231 and 232
cannot be enabled at the same time.
COS option 232 (Message Waiting Lamp).
Room Telephones.
This COS option lights
the message lamp on a room telephone
when there is a message waiting. See also
System Option 02 (Form 94). COS options
231 and 232 cannot be enabled at the same
time.
Form 04
Note:
COS option 231 only rings message
bells. COS option 232 lights message lamps
and rings message bells.
3. Select System Option 04 (Message Waiting
and Message Register Clear Print).
This also enables printing of single-line
reports for message register changes.
l3m-m 4-a 9
I-age IUI L
602 4-14
Revision 0
9109-098-802-NA
Issue 1