Mitel SX-200 Practices page 204

Features Description
.
.
.
.
.,
.
Press the
Forwarding
softkey. The display shows the current forward-
ing type and destination, if programmed.
Press the
Change
softkey. Softkeys appear for the types of forwarding
enabled in the set' s COS.
Select Call Forwarding -
Don' t Answer.
The display requests the des-
tination number.
Enter the destination number. If an invalid number is entered, the dis-
play shows INVALID NUMBER. Use the + softkey to back space
and erase the entry. Enter the correct number (can be a speedcall key,
if programmed) or press the
Current No.
softkey to restore the pre-
viously programmed destination, (if available).
Press the
Save/On
softkey. The display returns to normal. &VVD ON>
appears in the top right corner.
Call Forwarding - External Generic 1001,1002 and 1003
Description
This feature forwards all calls received based on one of the conditions
selected from above, to a Speed Call or system Abbreviated Dial number,
which is an external number.
Conditions
The following conditions apply to this feature:
.
.
.
I
.
.
.
.
.
105 2-132
Forwarding - External requires a receiver for dialing. If one is not avail-
able then forwarding is ignored in Call Forward - Don' t Answer. If it is
done during a reroute, the caller is dropped or given reorder tone.
An extension with COS Option 200 (Account Code, Forced Entry - Ex-
ternal Calls) in its COS cannot set up the External Forwarding feature.
Toll Control applies to the calling party for External Call Forwarding to
personal speed call keys.
Toll Control is not done for forwarding to external numbers using the
system Abbreviated Dial feature.
No Toll Control checking is done for CO trunks which are externally
call forwarded.
A trunk can only be forwarded externally if System Option 21 (Incom-
ing to Outgoing Call Forward) is enabled.
An extension is not forwarded to an external number unless it has
COS Option 208 (Call Forwarding - External) in its COS.
Campon to busy trunk groups after forwarding external is possible if
the caller is allowed to campon to trunk groups; see Campon.
Revision 0
9109-096-l 05-NA
Issue 1