Attendant Multi-New Call Tone - Mitel SX-200 Practices

Features Description
l
Press the FUNCTION key.
l
Press the GUEST ROOM softkey.
l
Enter the extension/room number softkey.
l
Press the SEND MSG softkey.
l
Press the EXIT softkey.
To cancel Message Waiting on an extension:
l
Press the CANCEL MSG softkey.
Attendant Multi-New Call Tone
Description
Conditions
- Programming
Operation
105 2-44
If an attendant is actively engaged with an incoming call, the first call
placed in the Attendant Call Waiting queue signals the attendant with a
single burst of tone. As long as there are one or more calls waiting in the
queue, the attendant will continue to hear the single burst of tone at the
programmed time interval. The presence of any calls waiting is also
shown by the call waiting indication on the top line of the display; see At-
tendan t Calls Waiting Display.
The following conditions apply to this feature:
l
This feature is disabled if the attendant bell is turned off from the con-
sole. Refer to Attendant Bell Off.
l
The frequency of the new call tone is controlled by COS Option 404
(Recording Failure to Hangup Timer).
l
This feature is only available in Generic 1003, Generic 1004 and
Generic 1005.
Enable COS Option 106 (Attendant New Call Tone) for the console.
Enable COS Option 122 (Attendant Multi-New Call Tone) for the console.
Set the desired time on COS Option 404 (Recording Failure to Hangup
Timer). The default for COS Option 404 is 30 seconds.
None
Revision 0
9109-096-l 05-NA
Issue 1