Mitel SX-200 Practices page 685

System Description
Guest Room Wakeup
A guest can be allowed to set and cancel a wakeup call from any room telephone by
dialing an automatic wakeup access code. Wakeup time must be in 24--hour format and
is entered by dialing from the telephone. Dial tone indicates a wakeup time has been
set or cancelled successfully.
If a guest room sets or changes a wakeup, a single line report SET BY ROOM or CHG
BY ROOM is printed.
Feature
Interactions
If a guest room telephone is programmed for Automatic Wakeup
Routing, the Automatic Wakeup Music option has,no effect,
Do Not Disturb is ignored on extensions when the wakeup is
honored,
System options 12 (Automatic Wakeup Alarm) and 13
(Automatic Wakeup Print) have no effect on
SUPERSET 4,
SUPERSET
4DN,
SUPERSET 420
or
SUPERSET 430
telephone operation of the feature. See the Programming
section.
Conditions
System Option 56 (Room Status Conversion/Auto Wakeup Print
Timer) only applies if System Option 34 (Auto Room Status
Conversion/Auto Wakeup Print) is enabled. See the
Programming section.
In the event of a power failure, all expired wakeups are honored
within
5
minutes of a system reset.
If a recording hunt group is used for wakeups, there can only be
one wakeup call per recording announcement device at any
given time. This means that if multiple wakeups have been set
for the same time, only one can proceed. All the others are
shifted. The amount of this shift is variable depending on:
-the time it takes for each preceding extension to
answer/acknowledge the wakeup
-the l-minute period between wakeups beino scanned,
How to program
Guest Room
Chart 4-9
Attendant
Chart 4-l 0
How to Use
Console: Chart 5-4, Chart 5-5
FDTI Chart 5-21, Chart 5-22
9109-096-602-NA
Issue 1
Revision 0
602 245