Mitel SX-200 Practices page 76

Features Description
l
The user of a SUPERSET4@, SUPERSETCDN, SUPEf?SET420",
or SUPERSET 430" telephone can also enter account code(s) during
a call.
l
A 'W' or a 'W is not allowed in an account code.
l
A "#I' is only allowed to be dialed if the account codes are of the vari-
able length type.
l
If no SMDR buffers are available, the extension user receives busy
tone when the account code entry is attempted.
l
If you enable Forced Account Codes for industry-standard telephones
that also have the Direct To ARS feature enabled, users must dial an
account code before they can originate a call.
l
The Direct To ARS feature applies to SUPERSETtelephones when a
valid account code has been entered.
l
The system will not force extension users to enter an account code for
an external call unless the SMDR feature is programmed to record the
call and the account code.
l
For SUPERSET 4, SUPERSET 4 DN, SUPERSET 420, and
SUPERSET 430 telephones, an account code can only be entered
during a call if the call is a 2-party call, the other party being a trunk (of
any type) *
l
For a SUPERSET 4 DN, SUPERSET 420 and SUPERSET 430 tele-
phones, the
Account Code
softkey is present, providing that a
consultation hold is not in progress and the set has completed dialing.
l
In addition to station and SUPERSETtelephones and consoles, DISA
and
Tte trunks can also access account codes. If an error is made
when entering a verified account code, the trunk is dropped.
Programming
To force an extension user, TIE or DISA trunk to use account codes for
long distance calls, enable COS Option 201 (Account Code, Forced Entry
- Long Distance Calls) for the device. Refer to Practice
9109-096-22C&NA, Automatic Route Selection and Toll Control, for the
-
designation of Long Distance calls.
To force an extension user tie or DISA trunk to use account codes for all
external calls, enable COS Option 200 (Account Code, Forced Entry -
External Calls) for the device's Class of Service.
Set Account Code Length (System Option 55) (44 in Generic 1001) in CDE
Form 04 (System Options/System Timers).
Assign a feature access code to Feature 01, Account Code Access in CDE
Form 02 (Feature Access Codes).
COS Option 700 (SMDR - Does Not Apply) must be disabled in the
extension's, or tie, or DISA trunk COS before the extension may use account
codes.
105 2-4
Revision 0 9109-096-l O!SNA
Issue 1