Mitel SX-200 Practices page 273

Features
If calling a station, SUPERSETtelephone, hunt group, or logical line
and the DID Routing Point is defined, then the trunk is rerouted to that
point.
If calling a busy industry-standard telephone, SUPERSETtelephone,
or logical line and the extension has forwarding - busy/always pro-
grammed, then the trunk is forwarded.
If calling a busy industry-standard telephone, SUPEEETtelephone,
logical line, or hunt group and the DID Recall Points on Busy is de-
fined, then the trunk is rerouted to that point.
If calling a station or SUPERSETtelephone with Do NotDisturb en-
abled and a Do Not Disturb Intercept point is defined, then the trunk is
rerouted to that point.
If the station or SUPERSETtelephone called does not answer and the
extension has forwarding - no answer programmed, then the trunk is
forwarded.
If the industry-standard telephone, SUPHXETtelephone, hunt group
member, or logical line called does not answer and the DID no answer
point is defined, then the trunk is rerouted to that point.
The above applies, except for DND intercept, for Tie trunks, but using the
equivalent Tie routing points.
Conditions 1
' he following conditions apply to this feature:
.
If an illegal number is dialed or an illegal feature is attempted and the
DID Intercept Routing point is defined, then the DID trunk is rerouted to
that point. The tenant of the trunk is used. The same applies for Tie
trunks and the Dial-in Tte Intercept point. If no point is specified, reor-
der tone is given.
.
.
.
9109-096-l 054A
Calls routed to an LDN or to a console through the DID/Tie intercepts
are identified as intercepted calls on the console display, when they are
answered.
Calls routed to an LDN through DID Intercept busy/no answer routing
point, show the tenant name of the called party when answered at the
console.
If a vacant number is dialed and the DID Vacant Number Routing point
is defined, then the DID trunk is rerouted to that point. The tenant of
the trunk is used. The same applies for Tie trunks and the Dial-in Tie
Vacant Number Routing point.
The DID or Tie no answer point applies in recall situations if the trunk
was ringing a party and has not been answered yet by any device in
the system (excluding recordings). See Last Number Reciial.
The reroute for no answer does not occur if calling a console, LDN or
Night Bell. It also does not occur if already ringing the reroute point.
The reroute point on busy or no answer cannot be a console.
Issue
1
Revision
0
105 2-201