Mitel SX-200 Practices page 617

Programming and CDE
6:E8 36-NOV-83 alarm status
q
MAJOR
I
1 [TENANT : 1
1
TYPE OF CALL
Station Dial 6 Routing
Priority Dial 6 Routing
DID Recall Points On Busy
DID Recall Points On No Anewer
DID Routing For Calls Into This Tenant
DID Illegal # Intercept For This Tenant
DID
Vacant Number Routing For This Tenant
DID Attendant Access Night Points
Non-Dial-In Trunks &lt.ernat.e Recall Points
Dial-In Tie Recall Points On Busy
Dial-In Tie Recall Points On No hnswer
Dial-In Tie Routing For Calls Into This Tenant
1511
Station Dial 6 Routing
l-
2-TENANT N&ME 3-
6-QUIT 7-TEN&NT 8-DEL6TE
4-TUP
3-
Figure 3-3 Call Rerouting Table
Note: For programming CDE Form 19, Call Rerouting Table, DID and Dial-In Tie Trunk
Attendant Night Access Points only work when the tie trunks are sent to the Attendant's
extension number and not to an LDN key on the console,
The following table defines which tenant controls the recall point for incoming calls that
are not answered by the destination station:
TYPE OF CALL CONTROLLING TENANT GROUP
DID Recall Points on Busy
DID Recall Points on No Answer
DID Routing for Calls into this Tenant
DID Illegal # Intercept this Tenant
DID Vacant Number Routing for this Tenant
DID Attendant Night Access Points
Non-Dial-In Trunks Alternate Recall Points
Dial-In Tie Recall Points on Busy
Dial-In Tre Recall Points on No Answer
Dial-In Tre Routing for Calls into this Tenant
Dial-In Tie Illegal # Intercept this Tenant
Dial-In Tre Vacant Number Routing for
this Tenant
Dial-In Tie Attendant Access Night Points
DND Intercept Routing for this Tenant
Destination Station
Destination Station
Destination Station
Calling Trunk
Calling Trunk
Calling Trunk
Note: Will not recall on
no answer if the ringing
destination is the trunks
Night I answering point.
Destination Station
Destination Station
Destination Station
Destination Station
9109-09(%23O-NA Issue 1 Revision 0
230 3-3