Mitel SX-200 Practices page 119

Features
busy tone. A SUPERSET telephone displays the message KICKED
OFF.
l
The console bell is turned off while the PAGE key is held down.
l
If System Option 03 (Single Paging Amplifier) is enabled then the At-
tendant cannot override the current pager user(s).
l
A console cannot override another console in a paging zone.
0 For paging on all zones simultaneously, all zones must be either not in
use or the console must be able to override the user of the zone(s).
0 While the PAGE key is held down, all other console keys are non-op-
erational.
l
When on a pager that has been accessed by a feature access code,
tone signalling can be turned on using the TONES ON softkey. See
Attendant Tone Signaling.
Programming Enable one or more of the following COS Options for the console in CDE
Form 03 (COS Define) as shown in the following table.
1 COS Option Number ( Description
I
303 ( Paging Zone 1 Access
I
I
304
Paging Zone 2 Access
I
305 Paging Zone 3 Access
306 Paging Zone 4 Access
307 Paging Zone 5 Access
I
308 1 Paging Zone 6 Access
I
309 Paging Zone 7 Access
310 Paging Zone 8 Access
311 Paging Zone 9 Access
312
I
Paging Default (0 to 9)
(0 Gives All Enabled Zones)
I
For access to the default zone, assign an access code to Feature1 2 (Paging
Access to Default Zone) in CDE Form 02 (Feature Access Codes).
Assign an access code to Feature 13 (Paging Access to Specific Zones) in
CDE Form 02 (Feature Access Codes) for access to zones other than the
default zones.
Operation To connect to the default paging zone, hold down the PAGE key. The con-
nection remains until the PAGE key is released.
To connect to a paging zone other than the default zone, dial the 'Paging
Access To Specific Zones' access code, followed by the desired paging zone
number (I-9).
9109-096-105-NA
Issue
1
Revision
0 105 247