Attendantsourcekey - Mitel SX-200 Practices

Features Description
l
The RING AGAIN softkey does not appear for a serial trunk call that
recalls back to the console (however it recalls).
l
A serial call that is released to a Subattendant will not have its recall
point changed to the Subattendant telephone; see Subattendant.
l
Enabling serial call clears any previous serial call setting by another
console and any recall point set up to any other device; see Recall.
l
Serial calls appear at the RECALL call position at the console; see At-
tendan t Default Call Positions.
Programming
Enable COS Option 109 (Attendant Serial Call) for the console.
Operation
To establish a Serial Call:
l
Answer an incoming trunk call.
l
Press the SERIAL CALL key.
l
Dial the required destination extension number.
l
Press the RELEASE key.
To answer a Serial Recall:
l
ANSWER lamp flashes and RECALL softkey appears.
l
Press the ANSWER key -ANSWER lamp is lit; SER, SRC, and SERI-
AL CALL is displayed on console.
9 The Attendant is connected to the recalling trunk.
To cancel a Serial Recall:
. ANSWER lamp flashes and RECALL softkey appears.
l
Press the ANSWER key -ANSWER lamp is lit; SER, SRC, and SERI-
AL CALL is displayed on the console.
l
Press the SERIAL CALL key and the RELEASE key; SERIAL CALL
goes out and the call is cleared.
Attendant Source Key
Description
This feature allows the Attendant to press the SOURCE softkey to speak
to the source party of a call, to swap between the source and destination
parties or to split up a conference call.
The source party's extension number, COS, and COR are displayed on the
first line of the console's LCD display and the destination party is put on
consultation hold.
105 2-50
Revision
0 9109-096-l
O!%NA
Issue 1