Mitel SX-200 Practices page 239

Features
Data: ADL Hotline
Description
Conditions
Programming Assign the hotline number in CDE Form 12 (Data Assignment).
Operation
To originate an ADL hotline call:
This feature establishes a data call between two preassigned DTEs when
the user dials the ADL access code from the associated telephone.
This feature is not available in Generic 1001,
Refer to Associated Data Line.
Dial the ADL access code. The call is automatically connected to the
preassigned destination. Also, a carriage return <CR> may be required
depending upon the programmed ADL Autobaud option, See Asso-
ciated Data Line - " O peration: ADL Call Originate" .
If the destination is busy and queuing is enabled, the originating station
is queued.
If the destination is not a valid data device, the message " I NVALID
#" a nd reorder tone is returned.
Data: ADL Speed Call Originate
Description
Conditions
Programming
An ADL user can originate an ADL call using a personal Speed Call num-
ber.
This feature is not available in Generic 1001.
None.
The programming procedure to be followed varies depending upon the
type of telephone to be programmed. Follow the appropriate procedure
described below:
SUPERSET 3
Telephones:
At the user' s telephone:
l
Press the PROGRAM/SAVE key while the set is idle (if a call is re-
ceived or originated, the telephone immediately exits from the
speedcall activity).
9109-096-105-NA
Issue
1
Revision
0 105 2-167