Attendant Advisory Message Setup; Attendantalarmreadout - Mitel SX-200 Practices

Features
Attendant Advisory Message Setup
Description
(,
There are eight default and seven programmable messages for use on
SUPERSET
4,
SUPERSET 4 DN, SUPERSET 420, and SUPERSET 430
LCD displays. The Attendant can read a set's currently displayed mes-
sage, or read through the available messages and choose one for display
on the set; see Messaging -Advisory.
Cbnditions None
Programming
None
Operation
To read all of the available messages, perform the following procedure:
l
Press the FUNCTION key.
l
Press the ATT FUNCTION softkey.
l
Press the STATIONS softkey.
l
Enter a SUPERSET 4, a SUPERSET 4 DN, a SUPERSET420, or a
SUPERSET 430 extension number.
l
Press the SET UP MSG softkey.
The messages will appear at the start of the second line on the console's
LCD display. All of the available messages can be read by pressing the
NEXT softkey. An OFF softkey is presented for the message currently
displayed (if any) on the specified SUPERSET 4 telephone. All other
messages will result in an ON softkey being presented.
To set up or remove a message from a SUPERSE7-4 telephone, enter the
same keys as above in the same order, and press the ON or OFF softkey as
required.
Attendant Alarm Readout
Description
The Attendant Console can display the alarm logs presently active in the
system. The Attendant can cause a readout of the alarm messages one
by one using the softkeys. The message indicates the fault and its loca-
tion
Conditions
For the Attendant to access the alarms, the following conditions must ap-
ply:
. There must be no other console accessing alarms.
9109-096-1054A
Issue
1
Revision 0 105 2-17