Mitel SX-200 Practices page 657

System Description
Once a room number (extension number) has been entered, the display changes to
the format shown in Figure 2-3 with a ROOM NUMBER softkey displayed in the FO
position. Pressing EXIT at any time returns the attendant console to its prior state (idle
or busy call processing).
In all releases (except Generic 1001 and Generic 1002), the following softkeys appear
on the attendant console display after pressing the GUEST ROOM softkey:
Enter Room Number:-
aFlb EXIT mF2bMAID IF3b VAC/CLEAN RM aF4b AUDITS mF5bOCC/DIRTJ
mF6b OCCKLEAN RMu FWREWCLEAN RM 1 F8b VAQDIRTY RM 1 F9b OUT OF SERV @ Fw
Figure 2-5 Console Display after Pressing GUEST ROOM Softkey
When one of the choices has been selected, the display is changed to the following:
TOTAL=
9 4800 4850 4900
4951 5005 5015
HFlb EXIT 1 F2bROOM NUMBER mF3b
mF4b
aF5b
BF~F
Drn
BF~F aF9B9 mF* MORE...
Figure 2-6 Console Display after Pressing VAC/DlRN FIM Softkey
The total number of rooms of the specified status, e.g. VAC/DlRn, appears in the top
left corner of the display if there is at least one room which fits that description. A
maximum of 6 room numbers will be shown on the same display. Pressing the MORE
softkey will display the remainder of the room numbers.
If there were no VAC/DlRTY rooms, the following display will appear:
Figure 2-7 Console Display if no VACYDIRN Rooms
The console display could also show no occupied and clean rooms, no vacant and
clean rooms, no occupied and dirty rooms or no reserved and clean rooms,
9109-096-602-NA
Issue 1
Revision
0 602 2-7