Mitel SX-200 Practices page 14

General Description
The 336port configuration consists of a single cabinet with four fully digital card bays
for a maximum of 336 digital peripheral ports. This configuration is used for new
installations rather than upgrades,
The 456port configuration combines a digital Control cabinet with an analog
peripheral cabinet. The 456port configuration has five card bays offering a maximum
of 240 digital and 216 analog peripheral ports.
Note: The 456-part
installed SX-200 PABX to an SX-200 DIGITAL PABX by adding a digital Control cabinet
to the existing analog cabinet.
The 480-port configuration is similar to the 456port configuration in that it combines
a digital control cabinet with an analog peripheral cabinet. The 480-port configuration
has five card bays offering a maximum of 144 digital and 336 analog peripheral ports.
Note: The 48O-port
installed 48O-port
The 672-port, 2-cabinet
maximum of 672 digital peripheral ports. This configuration is used for both new
installations and upgrades to existing 336port configurations. Since this system
accepts only digital peripheral cards, it is recommended for sites that use data features
extensively.
The SX-ZOO FD system consists of one Control cabinet and up to seven Peripheral
cabinets, Each Peripheral cabinet provides up to 96 ports, giving a combined total of
672 ports for a fully configured system.
Fiber optic cables connect the Control Cabinet with the Peripheral Cabinets. The
Peripheral Cabinets can be located up to 1 km from the Control Cabinet, allowing the
system lines (extensions) and trunks to be physically distributed among several remote
locations.
100 2-2
configuration is available only as an upgrade. Customers can upgrade their
configuration is no longer available for new installations. However, an
SX-200 PABX may be upgraded with new software Generics.
configuration has seven digital card bays providing a
Revision 0 9109-098-l OO-NA Issue 1