Mitel SX-200 Practices page 238

Features Description
105 2-166
the baud rate (this character must be entered within 30 seconds or the
call is released; otherwise reorder tone is heard and PLEASE TRY
LATER is displayed).
Connect tone is returned to the originator.
Hang up the voice telephone.
Call is switched to the associated dataset.
,,
Note:
Once the ADL call has been established, the telephone is free to be used. If a
voice call had been established, the other party can be placed on hold by
pressing the Tl?ANS/CONF key
(Flash
key on the SUPERSm 401
telephone), and the ADL call can be established. Pressing the CANCEL or
BACK TO HELD softkey reconnects the telephone to the party on hold.
When an ADL Call Origination is unsuccessful, reorder tone is returned and
one of the following messages is displayed on the display SUPERSET
telephone:
The voice telephone has not been programmed as an AVL to an asso-
ciated dataset. The set displays " N O ACCESS" .
The associated dataset is not idle. The set displays " P LEASE TRY
LATER" .
The user dials the number of a device which cannot handle data. The
set displays " I NVALID ##" .
The baud rates of the source and destination are not compatible and
neither have Flow Control programmed. The call is barred. The calling
set receives reorder tone and displays " N O ACCESS" .
The associated terminal is not asserting DTR and is NOT programmed
for auto-answer. The set displays " N O ACCESS" .
ADL Call Disconnect
The source or destination can disconnect an ADL call by:
l
dialing the ADL disconnect access code.
l
pressing a preprogrammed Attention or Break key on the terminal.
l
pressing the DISCONNECT key or the CALL/AnN key on the dataset.
l
by either dataset dropping DTR for the preprogrammed time.
If the call is not set up via the ADL feature, doing an ADL disconnect causes
the set to display " I NVALID #" .
Revision 0
9109-096-l 05-NA
Issue 1