Attendant Transparent Mu&Console Operation - Mitel SX-200 Practices

Features Description
9 Attempt a call to a busy extension.
l
Press the RELEASE key.
- this automatically camps on the calling party to the busy number. If
the transfer is not allowed then a beep tone is heard, CANT is dis-
played on the console, and no transfer is done
Attendant- Transparent Multi-Console Operation
r
Description
Conditions
Programming
Operation
105 2-54
The Attendant Transparent Multi-Console Operation feature allows some
features to apply to a group of consoles within a Tenant. Messages set by
any console in this group can be read or canceled by any consoles within
this group. Recalls to the RECALL softkey for any console in the group
can be answered by any of the consoles in the group.
The following conditions apply to this feature:
l
Transparent Multi-Console Operation must be enabled for each partic-
ipating console.
l
When a SUPERSET 4, SUPERSET 4 DN, SUPERSET420, or
SUPERSET 430 telephone user presses the CALL softkey to call the
console in response to a message received, if the message was left by
a console with the Transparent Multi-Console Operation feature en-
abled, the call is turned into a normal Dial 0 call and routes to the Dial
0 point of the SUPERSETtelephone.
Enable COS Option 320 (Transparent Multi-Console Operation) for each
console within this tenant that is to be a member of the group.
Assign access codes to the Dial 0 entry in CDE Form 19 (Call Rerouting
Table) for the tenant of the caller. To have the calls ring the attendant in the
group, the access code must be an LDN on the consoles in the console
group.
One attendant can read or cancel another attendant's message waiting
indications.
Calls that have been extended by one attendant will recall at multiple
attendant consoles.
Revision 0 9109-096-l 05-NA Issue 1