Mitel SX-200 Practices page 145

Features
Call Announce operates on a SUPERSET telephone regardless of
the type of device originating the call.
The user can perform a Call Announce via a Speedcall key or Abbre-
viated Dial number only.
The SUPERSET telephone must not be Handsfree (using the speak-
er) at the time.
The Call Announce Port can only handle one caller at a time.
If the Call Announce Port is busy then the call continues as usual as if
the SUPERSET telephone had been dialed directly.
;
The feature is ignored if the SUPERSET telephone has the Non-bu-
sy Extension feature enabled.
The call announce cannot be put on hold or consultation hold or con-
ferenced with a party on consultation hold.
Programming Program the set extension number followed by *5 into a Speed Call num-
ber or Abbreviated Dial number, as required.
Enable COS Option 501 (Override Announce) in the caller' s COS.
Program the Call Announce Port for the SUPERSET 4 telephone in CDE
Form 09 (StationlSUPERSETTelephones).
Operation
If a call is to be transferred, place it on Consultation Hold (flash the
switchhook, press the
Flash
key, or press TRANWCONF key, as appro-
priate for type of set).
Press the SPEED CALL key or dial the Abbreviated Dial number of the set
with the Call Announce Port (CAP).
The CAP answers automatically; make the announcement.
Hang up; if there is a call on hold, it rings or camps on to the destination.
9109-09&l 05-NA
Issue
1
Revision
0
105 2-73