Attendantdlsacodesetup - Mitel SX-200 Practices

Features Description
To override a call on a busy trunk:
l
Press the OVERRIDE softkey (see Conditions).
To force-release a non-idle trunk (a call in progress is dropped), enter the
following softkeys:
l
Press the FUNCTION key.
l
Press the ATT FUNCTION softkey.
l
Press the TRUNKS softkey.
l
Enter the desired trunk number.
l
Press the ATT ACCESS softkey.
l
Press the FORCE RLS softkey (see Conditions).
To release a trunk from Attendant access, press the RELEASE key.
Attendant DISA Code Setup
Description
This option allows the Attendant to change the Direct Inward System Ac-
cess (DISA) security code (Feature 19) in CDE Form 02 (Feature Access
Codes) that a DISA caller must dial to access the system.
Conditions
The following conditions apply to this feature:
l
The DISA code cannot conflict with the numbering plan.
l
The DISA code is limited to a maximum of five digits.
l
The DISA code cannot be displayed.
l
An Attendant cannot delete the DISA code; it may only be deleted via
CDE Form 02 (Feature Access Codes). Refer to Practice
9109-096-210-NA, Customer Data Entry, for further details.
l
While the DISA code (Feature 19) in CDE Form 02 (Feature Access
Codes) is being setup from the Console, CDE Form 02 cannot be ac-
cessed from Customer Data Entry. Similarly, while Feature 19 in CDE
Form 02 (Feature Access Codes) is being accessed from Customer
Data Entry, the DISA code cannot be changed from the console.
Programming Enable COS Option 103 (Attendant DISA Code Setup) for the console.
Operation
To change the DISA access code, perform the following procedure:
l
Press the FUNCTION key.
l
Press the ATT FUNCTION softkey.
105 2-34
Revision 0
9109-09&l
05-NA Issue
1